Description
Ø：300—–Kerf：4.4—–Body：3.2—–Z：60—–Type：15—–Al：30—–Trous d\\'ergots：COMBI3
CMT DPX circular blades are made of CERATIZIT® NANOGRAIN tungsten carbide, renowned for its exceptional performance and wear resistance.
Good to know:
In order to maintain cutting quality over time, it is strongly recommended to follow the resharpening instructions.
Tips for resharpening a CMT DPX blade
(blade life is only guaranteed if the blade is sharpened to the specified values)
– carefully follow the resharpening information indicated on the saw blade – re-sharpening follows a precise sequence: -> the first four sharpenings, sharpen only the front part of the tooth -> on the fifth sharpening, sharpen the top of the tooth. -> repeat this operation for all subsequent resharpenings – maximum feed speed: 0.7 mm/sec – maximum material removal rate per pass: 0.1 mm – use a very fine grain diamond disc – peripheral speed of the disc: 35 m/sec – use a water or oil refrigerant, filtration of 3 to 5 microns and cooled to 22° minimum – cooled work area with spray nozzles for refrigerant with a minimum pressure of 2 bar
